Rugged Ridge 2-inch Coil Spring Spacer Kit, 99-04 Jeep Grand Cherokee (WJ) - Manual (Page 2)

2
Picture #1
Picture #2
Picture #3
FRONT:
1. Secure and properly block the tires of vehicle on a level
concrete or asphalt surface.
2. Jack up front of vehicle and install jack stands under frame
behind the lower link rear brackets. Remove tires and front
shocks.
3. Loosen, but DO NOT remove the sway bar end link's lower
bolts at axle housing on both sides (see picture #1). Lower
front axle down until coil springs become loose. Remove the
bottom bolt and clip from left front coil spring (see picture #2).
4. Now remove both coil springs.
5. Install 2" coil spring isolator pads on top (front spring) of the
factory pads. Place the 2" spacer in the lower mount for the
rear spring. (See picture #4) Raise jack up so that enough
load is applied to hold coil springs in place. Reinstall spring
bolt and clip at bottom of left front coil. Install new shocks.
6. Completely lower vehicle to the ground. Now tighten the
sway bar endlink’s lower bolts loosened from step #3.
Picture #4
NOTE: Repeat steps 1 - 6 from above to complete rear installation