Rugged Ridge X-Clamp and LED Light Kit, Black, 1-Piece - Manual (Page 2)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Page 2/2
Rugged Ridge ® X-Clamp
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Patent Pending
1. Disassemble the X-Clamp Front and X-Clamp Back by loosening the jam nuts then removing the 4 bolts
and 8 jam nuts.
2. Determine the correct orientation to mount the X-Clamp by holding the X-Clamp Front and X-Clamp
Back to the tube. Rotate the X-Clamp pieces 90° to make sure you have the correct orientation.
6. Attach mounting tab to X-Clamp Back. Tighten to 8 ft-lbs.
Apply red Loctite(R) or equivalent thread sealer before
tightening threads of flat head screw.
7. Apply logo to recess in X-Clamp Front.
3. Select appropriate bolt length for your tube diameter. 2.5” and 3”
diameter tubes require jam nuts. Note: to prevent jam nut
interference with the high point of tube, keep jam nuts separate on
bolt shaft during install.
4. Attach X-Clamp to tube by gradually tightening all bolts evenly in
an “X” pattern. Tighten to 3 ft-lbs. Do not exceed 3 ft-lbs.
5. Tighten jam nuts to a snug fit. Do not over tighten. Make sure bolts
are tightened before tightening jam nuts.
2”
2.5”
3”
11030.01
11030.10
Keep jam nuts close
to X-Clamp Front and
X-Clamp Back
PATENT PENDING
Inspect and retourque fasteners after first 50
miles and frequently thereafter, particularly after use off-road.
DO NOT USE & REPLACE IF X-CLAMP OR FASTENERS BECOME
DAMAGED.
WARNING !
NOTICE