Rugged Ridge Replacement Seat Slider, 76-95 Jeep CJ & Wrangler - Manual (Page 3)

Track Sliders for Jeep® Seats
P/N: 13201.03
Step 6: Install adjuster arm onto left slider as before (Fig.3, 4, 5, and 6). Do not attach to seat
until adjuster arm has been installed.
After arm has been installed mount the left side slider to the seat (same as step #4).
Torque bolts to 22 ft/lbs using a #30 torx wrench.
Step 7: Install the seat and slider back in Vehicle.
Align the studs on the slider with the mounting holes located in the seat riser.
Re-install the (4) nuts that were removed in step 2. Tighten the nuts to 22ft/lbs
using the #30 torx wrench.
Additional grease may be added to slotted runners to help with
seat adjustment if needed.
Pg.3