Rugged Ridge Header Roll Bar Top, Black Denim, 97-06 Jeep Wrangler (TJ) - Manual (Page 2)

3. Locate 2 Velcro straps in each front corner of the Brief (Figure 4).
• Wrap Strap A over the top of the bar towards the inside of the vehicle (Figure 5). The Velcro of
Strap A should be facing outward from the roll bar.
• Strap B wraps around the outside of the roll bar.
• Attach Strap B to Strap A on the underside of the roll bar (Figure 6).
• Do both driver and passenger sides of the vehicle.
Figure 4 Figure 5
Wrap Strap A over top of roll bar
Strap A
Figure 6
Inside of Brief
Strap A
Strap B
Strap B Strap B
Figure 7
4. Locate the Velcro flaps on each side of the roll bar.
Open and wrap flaps around roll bar, pull tight and press
together to close (Figure 7). Do both driver and
passenger sides of the vehicle.
Figure 8
Part : 13581XX / 936XX (REV 2 – 7.27.08) Page 2 of 4
5. Locate the center strap along the central roll bar. Run
the center strap around the rear and under the central
roll bar forward to the Footman Loop near the top center
of the windshield. Run strap through Footman Loop and
feed strap through its buckle securely (Figure 8).