Rugged Ridge Header Roll Bar Top, Spice, 97-06 Jeep Wrangler (TJ) - Manual (Page 3)

NOTE: The rear straps can be fastened in two different methods:
Option 1 shows how to attach the Brief to your vehicle using J-Clips.
Option 2 shows how to attach the Brief to your vehicle around the rear shoulder
seat belts.
Option 1 (with J-Clip)
6. Feed the rear corner straps through the J-Clips (Figure 9) and place the J-Clip under a convenient
attachment point, such as a rear corner rail or floor loop (Figure 10).
Figure 9 Figure 10
Figure 11
7. Wrap the straps around the roll bar or seat belt
shoulder harness. Feed the loose end through the
buckle and pull tight (Figure 11). Be sure not to
interfere with the seat belts safety and operation.
Place the strap under the seat belt. Never install over
the seat belt strap.
Figure 12
8. Locate the two side straps near the central roll bar. For
each side, wrap the straps around the vertical roll bar,
then feed the loose end through the buckle on the
other end and pull tight (Figure 12). Tighten all straps
(including center strap). Tie off loose strap ends.
Part : 13581XX / 936XX (REV 2 – 7.27.08) Page 3 of 4
9. Re-adjust Velcro and tighten all straps to assure a
wrinkle-free fit.