Rugged Ridge Heavy Duty 8,500 lbs, Off Road Winch - Manual (Page 5)

VEHICLE RECOVERY ELECTRIC WINCH USE & INSTALLATION INSTRUCTIONS
5
Attach Solenoid Box to the tie bars over spool by hooking the Mounting Bracket around front tie bar and
securing at the rear with the  screws provided, making sure all cables are located between the solenoid
box and the tie bar.
C.
To avoid risk of severe injury to eyes and body when working around batteries and electrical components:
• Always wear eye protection and remove watches, jewelry.
• Never lean over battery or connection being made.
• Leave remote switch disconnected to prevent inadvertent spool movement and accident.
• Never route electrical cables: across sharp edges or through door jams; through or near moving parts; near
parts that become hot.
• If drilling or cable supports required, verify area is clear of fuel lines, brake lines and other electrical cables.
• Install insulating boots on all exposed terminal posts and assure wiring/cables remain insulated and
protected from heat, vibration and wear.
WARNING
Chemical and Fire Hazard
3.
Make solenoid box to vehicle battery connections after consulting wiring diagram and instructions.
Solenoid Box to Winch Motor Connections
A.
Connect short red cable (B) from control to red terminal (B) of motor.
B.
Connect black cable with yellow jacket (C) to yellow terminal (C) of motor.
C.
Connect short black cable with black jacket (D) to black terminal (D) of motor.
D.
Connect thin black cable (E) to bottom terminal (A) of motor.