Rivera Primo Stiffeytm - Manual (Page 2)

NOTE: It is best to install the Stiffey TM one side at a time to avoid losing alignment of
the rear fork with the frame.
Remove the rear fork bracket to expose the end of the rear fork shaft by removing the two hex
head bolts. (Figure 5 & 6)
You are now ready to install the Stiffey TM onto the pivot shaft. To make it a little easier to slide the
Stiffey TM onto the pivot shaft, we recommend applying a small amount of grease to outside of the
body as well as to the spacer. (Figure 7 & 8).
Figure 5 Figure 6
Figure 7 Figure 8
Figure 9
Install the Stiffey TM onto the pivot shaft by aligning the offset hole in the Stiffey TM with the offset
pivot pin in the swingarm. Push down on the Stiffey TM with both thumbs until the Stiffey TM is fully
seated. (Figure 9, 10 & 11)
Figure 10