Bell & Gossett 10-001-275 XLS Integrated Pump Controller - Manual (Page 10)

10
MODES OF OPERATION
The HMI will display various modes of operation with
dedicated screens. These modes of operation can be
accessed through the interface on the home screen.
1.
IDLE MODE will be active when the unit is not in
[MANUAL] or [AUTO] and the pumps will not be
allowed run.
Figure 15: Basic Booster Idle Screen
2.
Auto Mode is activated /deactivated by tapping
[AUTO]. To enter or exit this mode of operation
simply tap [AUTO] from the IDLE screen.
*Details on setting up the station for proper AUTO
operation are detailed in the startup procedure.
3.
Manual Mode is activated/deactivated by tapping
[MANUAL] from the home screen. When activated,
a dedicated screen will appear as shown in Figure
16 to allow manual operation of individual pumps.
Figure 1 6 : Basic Booster Manual Screen
a. [ON], allows for the manual ability to turn on/off
the pump.
Figure 1 7 : Manual on/off
b. The PERCENT SPEED displays the current set
speed.
By tapping , an Enhanced Screen shown in
Figure 18 will appear and allow for manual control
of the pump speed and status.
Figure 1 8 : Manual Pump Control Screen
a
b