Comfort-Aire VMH 36 Series - Manual (Page 9)

9
Heat Controller, Inc. VMH 30/36 SERIES Owner’s Manual
9 10
Cleaning the Grille, Case and Remote Controller
CARE AND MAINTENANCE
Care and maintenance
Turn the system off before cleaning. To clean, wipe with
a soft, dry cloth. Do not use bleach or abrasives.
NOTE: Supply power must be disconnectd before
cleaning the indoor unit.
Cleaning the air filter
A clogged air filter reduces the cooling efficiency of
this unit. Please clean the filter once every 2 weeks.
1. Lift the indoor unit panel up to an angle until it
stops with a clicking sound.
2. Hold the handle of the air filter and lift it
up slightly to remove it from the filter holder,
then pull it downwards.
3. Remove the AIR FILTER from the indoor unit.
Once every two weeks,
with a vacuum cleaner or water, then dry it
in cool place.
clean the AIR FILTER
Filter Handle
OPERATING INSTRUCTIONS
AUTO operation
When you set the air conditioner to AUTO mode, it will
automatically select cooling, heating or fan only
operation depending on what temperature you
have set and the current room temperature.
The air conditioner will control room temperature
automatically around the temperature set point you
selected.
If the AUTO mode is uncomfortable, you can select
desired conditions manually by changing the mode to
cooling, heating, or fan only directly.
SLEEP operation
When you push SLEEP button on remote controller
during cooling, heating, or AUTO operation, the air
conditioner will automatically increase (cooling) or
decrease (heating) per hour for the first 2
hours, then hold steady for the next 5 hours, after that
it will switch off. This characteristic maintains both
energy saving and comfort in night operation.
DRYING operation
The fan speed will be automatically controlled under
dry operation.
During the dry operation, if the room temperature is
O lower than 50 F( , the compressor stops operation
and restarts when the room temperature is above
O 54 F( .
Optimal operation
To achieve optimal performance, please note the
following:
Adjust the air flow direction correctly so that it is not
directed on people, but rather in the room
Adjust the temperature to achieve the highest comfort
level. Do not adjust the unit to excessive temperature
levels.
Close doors and windows on COOL or HEAT modes,
or performance may be reduced.
Use TIMER ON button on the remote controller to
select a time you want to start your air conditioner.
Do not put any objects near air inlet or air outlet, as the
efficiency of the air conditioner may be reduced and
the air conditioner may stop running.
Clean the air filter periodically, otherwise cooling or
heating performance may be reduced.
Do not operate unit with horizontal louver in the closed
position.
O O 2 F/1 C
O 10 C)
O 12 C)
Operational modes
1 hour 1 hour
Set
Temperature
Set
Temperature
Cooling
Heating
SLEEP operation
1 hour 1 hour
SLEEP operation
7 hours timer off
7 hours timer off
SLEEP operation
A cloth dampened with cold water may be used
on the indoor unit if it is very dirty. Then dry it
with a dry cloth after cleaning.
Do not use a chemically treated cloth or duster to
clean the unit.
Do not use benzine, thinner, polishing powder, or
similar solvents for cleaning. These may cause
the plastic surface to crack or deform.
O Never use water hotter than 40 C to clean
the front panel, it could cause deformation of
discoloration.
O 104 F/
CAUTIONS
Do not touch the metal parts of the unit when
removing the filter. Injuries can occur when
handling sharp metal edges.
Do not use water to clean inside the air conditioner.
Exposure to water can destroy the insulation,
leading to possible electric shock.
When cleaning the unit, first make sure that the
power and circuit breaker are turned off.
Caution
Cleaning the air filter
OPERATING INSTRUCTIONS