Comfort-Aire RADS-121G - Manual (Page 10)

Owner’s Manual Room Air Conditioner with R-410A Heat Controller, Inc.
9
AIR CONDITIONER FEATURES(CONTINUED)
FOLLOW ME FEATURE:
(on some models)
Light flashing
NOTE:
To activate the Follow Me feature, point the remote
control towards the unit and press the Follow Me
button. T
If the unit
does not receive the Follow Me signal during any 7
minute interval, the unit will beep to indicate the
Follow Me mode has ended.
The actual temperature can be displayed at the unit
by pressing the Fan Only mode. When in the Cool
mode, the unit display indicates the set temperature.
he remote display is actual temperature
at its location. The remote control will send this
signal to the air conditioner every 3 minutes interval
until press the Follow Me button again.
This feature can be activated from the remote
control ONLY. The remote control serves as a
remote thermostat allowing for the precise
temperature control at its location.
ADDITIONAL THINGS YOU SHOULD KNOW
Now that you have mastered the operating procedure, here are more features in your control that
you should become familiar with.
The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on
quickly. This prevents overheating of the compressor and possible circuit breaker tripping.
The fan will continue to run during this time.
The control will maintain any set temperature within 2 F, between 60 F and 90 F degrees.
The control is capable of displaying temperature in degrees Fahrenheit or degrees Celsius.
To convert from one to the other, press and hold the Left and Right Temp/Timer buttons at the
same time, for 3 seconds.
Fresh Air Vent Control(on some models):
Figure 1 (VENT CLOSED)
Figure 2 (VENT OPEN)
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig.1)
2. Draw fresh air into the room- Vent Open (see Fig.2)
3. Exchange air from the room and draws fresh air into
the room - Vent and Exhaust Open (see Fig.3)
Figure 3 (VENT & EXHAUST OPEN)
9
Check
Filter
Cool Auto Low Auto
Mode Fan
Fan Dry Med High
Follow
Me Energy
Saver
On/Off
Sleep Clean
Air
This feature can be activated from the remote
control ONLY. The remote control serves as a remote
thermostat allowing for the precise temperature control
at its location rather than from the unit’s temperature
sensor.
To activate the Follow Me feature, point the remote con-
trol towards the unit and press the Follow Me button. The
remote display is actual temperature at its location. The
remote control will send this signal to the air conditioner
every 3 minutes until the Follow Me button is pressed again.
If the unit does not receive the Follow Me signal during any
7 minute interval, the unit will beep to indicate the Follow Me
mode has ended.
The actual temperature can be displayed at the unit by
pressing the Fan Only mode. When in the Cool mode, the
unit display indicates the set temperature.
The cooling circuit has an automatic 3 minute time delay start if the unit is turned off and on quickly.
This prevents overheating of the compressor and possible circuit breaker tripping. The fan will
continue to run during this time.