Comfort-Aire RADS-121G - Manual (Page 12)

Owner’s Manual Room Air Conditioner with R-410A Heat Controller, Inc.
11
C: Align the hole in the top rail with those in the
top of the unit as shown in Fig.B
Fig.B Fig.C
D: Secure the top rail to the unit with the 3/8
Screws as shown in Fig.C.
NOTE: For safety reasons, all four(4) screws
MUST be securely fastened.
,,
HOW TO INSTALL
NOTE: Top rail and Sliding Panels at each side are offset to provide the proper pitch to the rear of
(5/16 ). This is
Place unit on floor, a bench or a table. There is a Left and Right Window Filler Panel- be sure
to use the proper panel for each side. When installed the flange for securing the panel in place to
the window sill will be facing into the room.
necessary for proper condensed water utilization and drainage. If you are
not using the Side Panels for any reason, this pitch to the rear must be maintained.
,,
1
Fig.1
A. Hold the Accordion Panel
in one hand and gently
pull back the center to free
the open end. See Fig.1.
Fig.2A
Fig.2B
B. Slide the free and (I section)
of the panel into the cabinet
as shown in Fig. 2A, 2B & 3.
Slide the panel down., Be
sure to leave enough space
to slip the top and bottom of
the frame into the rails on
the cabinet.
Fig.3
11
NOTE: Top rail and Sliding Accordian Panels at each side are to provide the proper pitch to the rear of the
unit (5/16”). This is necessary for proper condensed water utilization and drainage. If you are not
using the Side Panels for any reason, this pitch to the rear of the unit must be maintained.
Place unit on a solid surface. There is a Left and Right Window Filler Panel-be sure to use the
proper panel for each side. When installed, the flange for securing the panel in place to the window
sill will be facing into the room.
end