Comfort-Aire REG-253G - Manual (Page 13)

Heat Controller, Inc. Room Air Conditioner with R-410A Owner’s Manual
12
12
Window Mounting
1 Remove Chassis
1. Pull down front panel and remove filter.
(See Fig.1).
2. Lift front upwards and place to one side.
3. Locate the four front screws and remove.
These screws will be needed to re-install
the front later. (See Fig.2).
6. Remove shipping screws from top of unit and
also on the side by the base if installed.
7. Hold the cabinet while pulling on the base
handle, and carefully remove the unit.
8. Add two foam inserts to holes in top of cabinet
where shipping screws were removed from.
9. Your unit may come with internal packaging.
This packaging must be removed prior to
installing the air conditioner back into the
cabinet.(see Fig.5).
4. Pry away front from cabinet sides as shown in
Fig.3.
5. Gently lift front off unit and place to one side
(see Fig.4).
2 Install Top Angle and
Side Bracket
1. Attach foam gasket to top angle
above holes as shown in Fig.6.
2. Install top angle and side retainers
to cabinet as shown in Fig.6.
3 Assemble W indow Filler Panels
1. Place cabinet on floor, a bench, or
a table.
2. Slide section of window filler panel
into side retainer on the side of the
cabinet (see Fig.7). Do both sides.
I , , , ,
Plastic
Frame Window Filler
Panel
Side Retainer
Fig.7
Fig.6
5 1
6
lon
g
hex
-he
ad
/
nearby.
nearby.
Place cabinet on a stable surface such
as on the floor, a bench or a table.
base, if installed.