Comfort-Aire REG-253G - Manual (Page 14)

Owner’s Manual Room Air Conditioner with R-410A Heat Controller, Inc.
13
3. Insert top and bottom legs of window
filler panel frame into channel in the
top angle and bottom rail. Do both
sides.
4. Insert washer head locking screws
(2) into holes in top leg of filler panel
frame (see step 6). Do not totally tigh-
ten. Allow leg to slide freely. Screws
will be tightened after section 6.
4 Install Top Angle and
Side Bracket
3. Shift cabinet left or right as needed to line up
center of cabinet on center line marked on stool.
4. Fasten cabinet to window stool with 2 screws
into holes(You may wish to pre-drill pilot holes).
5. Add bottom rail seal over screws to window stool.
1. Open window and mark center of window stool.
2. Place cabinet in window with bottom stool angle
firmly seated over window stool as shown. Bring
window down temporarily behind top angle to
hold cabinet in place.
Stool
Stool
Angle
13
5 Install Suppor t Bracket
1. Hold each support bracket flush against
outside of sill, and tight to bottom of cabinet
as shown below. Mark brackets at top level
of sill, and remove.
2. Assemble sill angle bracket to support
brackets at the marked position, as shown.
Hand tighten, but allow for any changes later.
Top
View
Air Conditioner
Cabinet
Plastic
Frame
I Section
Window
Filler
Panel
Locking
Screw
Hole
Bottom
Rail Seal
3 4 Long
Hex-head Screw
Mark
1 2 Long Screws
And Locknuts
Left
Right Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Locknut
sill.
sill angle
sill as shown. Bring
Sill
Sill
sill.
sill.
still with 2 screws