AT&T 902 - Manual (Page 2)

I N S TA L L AT I O N
NOTE: This telephone requires a
2-line modular jack or two separate
one-line modular jacks to use this
unit as a two-line phone .
NOTE: To use both lines of a two-
line telephone, your local telephone
company must provide two telephone
numbers.
Batteries
B e fo re using the telep h o n e, yo u
should install AA bat t e ries (not
i n cluded). If you are connecting
o n ly Line 1 or only Line 2, use two
b at t e ri e s , as indicated on the bottom of
the phone. If you are connecting both
l i n e s , use four bat t e ri e s .
You can use the phone without
batteries to make and receive calls,
but it requires batteries to power the
Line Status lights.
If you have wall-mounted the
telephone, follow these directions:
1 Remove the telephone from
the wall.
2 Turn the telephone upside down.
3 Remove the base by pressing the
tabs located on the top of the base.
4 Press down on tab on batter y
door located between arrows on
battery door (Figure 2A). Swing
door open and insert new batteries
(Figure 2B).
5 Close the battery door.
C AU T I O N : A lways unplug the line
c o rd befo re installing new AA bat t e ri e s .
Conferences
both lines
Directory Card/Cover
Line 2 Ringer Volume
Accesses memory
dialing numbers
Redials last call made, or starts Auto Redial
Mutes a call
Access Call Waiting
or other services
Temporary
Tone
Line 1 Ringer Volume
Press down on tab to
open battery door
Insert 2
AA batteries
for Line 2
Insert 2
AA batteries
for Line 1
BATTERY DOOR CLOSED, BASE OFF
BATTERY DOOR OPEN, BASE OFF
Handset
Line selection
Line Status
Lights
Programs a number
in memory
Programs a pause
in memory
Puts a call on hold
Turn speaker on or off
Speaker/Handset Volume
Figure 3
Figure 1
Figure 2B
Figure 2A