Silverline 18V Combi Hammer Drill - Manual (Page 9)

8
GB
Problem Possible cause Solution
Red LED does not illuminate and Battery (10) not charging
Battery not fully seated Clean Battery Connector (11) socket
Charger (13) not powered Recheck mains connection
Battery has low capacity
Battery not being fully charged Charge the Battery for 4 – 5 hours
Battery charged days before use Charge the previous day or same day as use
Battery has been charged over 100 times and capacity has
started to reduce This is normal for batteries. Contact your Silverline dealer to
purchase a replacement battery
Drill cannot be switched on
(Trigger Switch (7) does not move) The Forward/Reverse Switch (6) may be in the middle
(“locked”) position
Slide the Forward/Reverse Switch either to the left or right
Drill does not start when Trigger Switch is pressed
Battery completely discharged Recharge battery or replace with a fully charged battery
Defective battery Replace battery
Drill machine defective Contact your Silverline dealer or authorised service centre
Screws do not reach deep enough into the workpiece
Not enough torque; Torque Selector (3) setting too low Choose a higher torque setting
Low battery voltage Recharge battery or replace with a fully charged battery
Screws are driven too deep into the workpiece surface Too much torque; Torque Selector (3) setting too high Choose a lower torque setting
Drilling performance poor with masonry
Hammer mode not selected Enable hammer mode
Drill bit tip worn or damaged Replace drill bit
Very dense material
Drilling speed will be slow in such material. A smaller pilot drill
can be drilled first to speed up the drilling process
Troubleshooting
248196_Z1MANPRO1.indd 8 28/11/2013 16:17