Silverline Blower Vacuum 2500W - Manual (Page 7)

6
GB
Unpacking Your Tool
• Carefully unpack and inspect your tool. Fully familiarise yourself with all
its features and functions
• Ensure that all parts of the tool are present and in good condition. If
any parts are missing or damaged, have such parts replaced before
attempting to use this tool
Operating Instructions
Vacuum tubes:
• Attach the Vacuum Tubes (1) prior to usage using the screws and bolts
provided
NOTE: If the tubes are incorrectly fitted to the unit it could result in a severe
loss in performance.
Vacuum bag:
• Clip the Vacuum Bag (8) onto the lower retaining hook then snap-fit the
mouth of the bag onto the Debris Exhaust (7)
Shoulder strap:
• Attach the Shoulder Strap (3) to the anchor point prior to use. Adjust the
strap so that the unit falls comfortably around the waist
NOTE: Do not use the unit without the shoulder strap.
Using your Vacuum Blower
Operating as a blower
1. Ensure the Selection Lever (6) is pointing down; this changes the unit to
blower mode
2. Turn the blower on by moving the On/Off Switch (4) forward so that the
'I' symbol is displayed
3. Grip the vacuum blower by both handles (2 & 5) and point directly at
the debris
4. Sweep the unit gently from side to side, blowing the debris into one
location
NOTE: Ensure the end of the unit is always at least 15cm above the ground
NOTE: If performance seems to be restricted, you may need to remove the
vacuum bag.
5. When finished, turn the vacuum blower off by moving the On/Off Switch
(4) back so that the '0' symbol is displayed
Operating as a vacuum
1. Ensure the Selection Lever (6) is pointing upwards; this changes the unit
to vacuum mode
2. Turn the vacuum on by moving the On/Off Switch (4) forward so that the
'I' symbol is displayed
3. Grip the vacuum blower by both handles (2 & 5) and point directly at
the debris
4. Sweep the unit gently from side to side as it sucks up the debris
NOTE: Ensure the end of the unit is always at least 15cm above the ground
NOTE: Ensure the vacuum bag is securely attached to the unit
5. When finished, turn the vacuum/blower off by moving the On/Off Switch
(4) back so that the '0' symbol is displayed
WARNING: Ensure the selection lever is not half-way between the blower
and vacuum selections as this could cause damage to the unit and may
invalidate the warranty.
Maintenance
Always turn off and unplug the vacuum blower, and allow to cool fully,
before performing any cleaning or maintenance.
Cleaning
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and shorten the machine’s service life
• Use a dry cloth or brush to remove any debris that may be blocking the
vents
Disposal
• Do not dispose of power tools, or other waste electrical and electronic
equipment, with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of tools
Product Familiarisation
1 Vacuum Tubes
2 Handle
3 Shoulder Strap & Strap Anchor Point
4 On/Off Switch
5 Main Handle
6 Selection Lever
7 Debris Exhaust
8 Vacuum Bag
731590_Z1MANPRO1.indd 6 16/12/2011 09:22