Maintenance, Disposal – Silverline Water Butt Pump 350W User Manual

Page 7

Advertising
background image

6

GB

NOTE: When power is switched on, the pump will activate immediately.
Overheating

Should the pump overheat, it will automatically cut out.

•

Once the thermal overload switch has cooled down (after approx. 10

•

mins), it will reset and automatically switch on.
The possible cause may be due to an obstruction.

•
De-aeration

The pump is equipped with an automatic de-aeration device that will

•

remove air locks that could form in the pump.
If the pump is allowed to draw off water to the bottom of the unit, the

•

pump will have sucked in air, affecting its performance until it is able to
de-aerate.
Should this oocur, disconnect the pump from the mains power.

•

The de-aeration process will only be possible once the water level has

•

risen above the bottom of the pump i.e. when it is no longer able to
suck in air.
The power needs to remain off for a minimum of one minute, then it can

•

be reconnected, when the pump will automatically de-aerate.

Maintenance

Cleaning the filter
The following is the only maintenance that should be carried out by the
end user:

If the pump is dismantled to any degree other than as described below,

•

any claim will be invalidated under warranty.

WARNING: Disconnect the pump from the mains supply before undertaking
this work.

In the event that the suction base (3) becomes blocked, remove the 4

•

crosshead screws from the suction base that will release the base from
the body of the pump.
Check for any obstructions within the exposed area i.e. small stones or

•

gravel. it is suggested you also rinse this area of the base and the mesh
filter with clean water before re-assembling the base. If used to pump
chlorinated water or any liquid with residues, the pump should be rinsed
after use with clean water.

WARNING: Disconnect the product from the mains supply BEFORE any such
work is undertaken. When not in use, protect the pump from frost damage
and store in a dry place. No further disassembly should be undertaken.

Disposal

Do not dispose of power tools, or other waste electrical and electronic

•

equipment, with household waste.
Contact your local waste disposal authority for information on the proper

•

way to dispose of tools.

Advertising