SawStop Fence Assembly - Manual (Page 6)

Installing Your Fence Assembly
straight-edge
4 SawStop Contractor Fence Assembly
7. Use a straight-edge to level the rear edge of the left extension wing to
the cast iron table top (see Fig. 7). You may have to pull up or push
down on the outer edge of the extension wing to level it. Once the rear
edge of the left extension wing is level, use 13 mm wrenches to fully
tighten the hardware that mounts the left rear rail. Repeat this process
to level the rear edge of the right extension wing and to secure the
right rear rail to the saw.
8. Locate the material support shelf, the two large storage hooks and the
two small storage hooks. Take the material support shelf and insert two
M8 x 20 square head screws from hardware pack #3 into the holes on one
end. Loosely place an M8 lock washer and a M8 hex
nut on the back of each screw, but do not tighten the
nuts (see Fig. 8).
17
18
16
Fig. 8
9. Position the material support shelf between the front rail and the right rear rail by sliding the heads of the two
square head screws into the slot on the right end of the front rail until the holes in the rear of the material
support shelf line up with the holes in the
rear rail. Use two M8 x 16 hex screws, two
M8 lock washers, and two M8 hex nuts
to mount the material support shelf to the
rear rail (see Fig. 9). Use a straight-edge to
level the top of the material support shelf
with the cast iron table top. Use two 13 mm
wrenches to fully tighten the hardware that
mounts the material support shelf to the
right rear rail. Do not tighten the hardware
that mounts the material support shelf to
the front rail.
17
19
18
30
45
SawStop
10” Contractor Saw
Fig. 9
Installing the Fence Rails Assembly
Hardware for Steps 1-11
Square Head Screws, M8 x 20
(10 + 1 extra) 16
Lock Washers, M8
(22 + 1 extra) 17
Hex Nuts, M8
(18 + 1 extra) 18
Hex Screws, M8 x 16
(8 + 1 extra) 19 Carriage Bolts,
M8 x 20 (4) 20
Hardware Pack # 3
Sa w St op
Fig. 7