SawStop ICS73600 - Manual (Page 27)

SawStop 10” Industrial Cabinet Saw 25
Setting Up
Your Saw
12. Disconnect Switch:
The saw is equipped with an electrical disconnect switch
mounted on the left side of the cabinet. When the disconnect
switch is switched to OFF (see Fig. 22), electrical power is
physically disconnected from the entire saw, including the
SawStop safety system. The disconnect switch should be
switched to OFF whenever performing any adjustments,
maintenance or repairs to the saw, including changing
blades, installing or removing the blade guard and riving
knife, etc.
Setting Up Your Saw
In addition, the disconnect switch can be locked in the OFF
position with a padlock or similar device as shown in Fig. 23. The
disconnect switch should be locked in the OFF position whenever
there is a possibility of someone accidentally applying power to
the saw while adjustments, maintenance or repairs are being
made.
When the saw has been completely installed and is ready
for use, turn the disconnect switch to ON as shown in
Fig. 24.
Fig. 24
Fig. 23
Fig. 22