SawStop ICS73600 - Manual (Page 32)

30 SawStop 10” Industrial Cabinet Saw
4. System Status Codes:
The LED lights on the front of the switch box display the current status of the safety system. Each light may be
off, or may be on, and if it is on, it may be blinking slowly, blinking quickly, or not blinking at all, which we call
“on solid.” Together, the red and green lights display a code, referred to as the System Status Code, which tells
you if the saw is operating normally or if there is a problem. When you first turn the Main Power switch on, the
safety system will complete an initialization routine to verify the safety system is operating normally. After the
initialization routine is completed, you should not see the red light
unless there is a problem. If this happens, find the System Status
code below (see Fig. 31) to determine how to correct the problem.
WARNING! Always switch both the Disconnect Switch and the Main Power
Switch to OFF before performing adjustments or maintenance to the saw.
Using Your Saw
SawStop
System Status Codes
Status Red Grn
¯ ¯ ¯
System Initializing
System Ready
Replace Cartridge
Coasting Down
Bypass Mode On
Push Start/Stop
Paddle To OFF
Turn Cartridge
Key To ON
No Blade Rotation
See Manual
Adjust Position of
Brake Cartridge
Contact Detected
During Standby
Contact Detected
During Bypass
Overload Due To
Wet Wood
• • • • • •
¯ ¯ ¯
¯ ¯ ¯
• • • • • •
¯ ¯ ¯
• • • • • •
• • • • • • • • • • • •
• • • • • •
¯ ¯ ¯
• • • • • •
Fig. 31
Green LED blinks fast
Green LED blinks slowly
Green LED is on solid
Red LED blinks fast
Red LED blinks slowly
Red LED is on solid
Symbol Key: