Muxlab LongReach II Active CCTV Receiver Hub - Manual (Page 14)

© MuxLab. LongReach II Active CCTV Receiver Hub Installation Guide
Page 14
4. If remote power, video and PTZ control is to be
transmitted, use 500022 balun. Refer to the
specification table regarding maximum distances
and set the slide switch on the LongReach II Hub to
“500022”. Connect the outputs of the 3
rd party PTZ
controller to the control terminals on the hub.
5. Ensure that the power is off on the DVR and then
connect the LongReach II Hub to the appropriate
video input port.
6. Connect the plug from the 5 VDC power supply. If
power is present, then the green LED will be ON.
7. Connect one Cat5e cable to each RJ45 on the
LongReach II Hub. Please note that the hub is not
polarity sensitive.
8. Power on the CCTV system. When a video signal is
detected, the AGC Lock LED on the LongReach II
Hub will change from OFF to ON.