Page 8 – Muxlab LongReach II Active CCTV Receiver Hub User Manual
Page 8
© MuxLab.
LongReach II Active CCTV Receiver Hub Installation Guide
Page 8
Specifications (Cont’d)
RJ45 Pin
Configuration
Signal
500022 Mode
500024/500029
Mode
*Reverse polarity
sensitive if 12DC
camera is used
*Power A (+)
1, 3
1, 3, 5
*Power B (-)
2, 6
2, 4, 6
Control (+)
4
NA
Control (-)
5
NA
Video BNC Center
(Tip)
7 [T] same as
500000R
7 [T] same as
500000R
Video BNC Ground
(Ring)
8 [R] same as
500000R
8 [R] same as
500000R
Connectors
Video Out: BNC-F (8 or 16)
Remote Power: 2-pole screw terminal
block (8 or 16)
PTZ: 2-pole screw terminal block (8 or
16)
Cat5e/6 Link: RJ45S (8 or 16)
Power connector.GND screw terminal
Power Supply (included)
Current drawn per unit
5VDC 2.6 A max. Floating.
Interchangeable blades
500126 (8-port): 0.79 A max.
500127 (16-port): 1.53 A max.
Transient Voltage Protection
± 2.5V on the video line
± 48V on the power and control lines
AC/DC power surge protection
Above 34VAC RMS or +/-48 VDC.
Fuse Protection
Auto-resettable fuses on 5VDC input
and Power A (+) upon power cycling.
Temperature
Operating: 0° to 55°C. Storage:-20° to
85°C. Humidity: up to 95%