Muxlab HDMI 4×4 Matrix Switch Kit, HDBT, PoE - Manual (Page 43)

© MuxLab Inc. HDMI 4x4 Matrix Switch, HDBT Installation Guide
Page 43
11. Reset
reset -f
Description: Reset the unit and restore it to its factory settings
Arguments: <none>
Example: Reset unit and restore it to factory settings
reset -f
Response: “Clearing flash memory...
Rebooting...”
(or an error message if the command failed)
12. Sending Data
senddata –p
<port #> -b <baud rate> -d “
<data to send >
“
Description: Send pass through data to a specific output port
Arguments: <port # >: 1 to 4
<baud rate>: 9600, 19200, 38400, 57600 or 115200
<data to send>: Hex string (max 80 characters)
Example: Send the following 4 bytes to port #3 0xA1, 0x55, 0xF2, and 0xC8
senddata –p 3 –b 9600 –d “A155F2C8”
Response: [“0304A1B2C3D4”]
Where:
03 = port number
04 = date length that follows (max value 0x28 bytes.)
A1B2C3D4 = data in hexadecimal (0xA1, 0XB2, 0xC3, 0xD4)
Command performed successfully
(or an error message if the command failed)
12. Status of the serial output port
serialdata –o
<port #> <port state >
Description: Enable/Disable serial port for specific output port
Arguments: <port # >: 1 to 4
<port state>: on or off
Example: Disable serial port of output 3
serialdata –o 3 off
Response: Serial Data Status : [1,1,0,1]
(or an error message if the command failed)