Chemglass 30L thru 50L Jacketed - Manual (Page 3)

www.cglifesciences.com [email protected]
Overhead Stirrer Motor
Air Motor 1/4 HP Vertical Motor
1/4 HP Horizontal Motor Explosion Proof (XP) Motor
The motor is installed on the support frame when shipped. Use the following instructions should you need to remove or
adjust these components.
Components Needed for Overhead Stirrer Motor:
1ea
CG-2033-11 1/4 HP Vertical Electric Stirrer Motor
1ea CG-2033-13 1/4 HP Horizontal Electric Stirrer Motor
1ea CG-2025-20 Air Motor* (Optional)
1ea CG-2033-31 Digital Electric Stirrer Motor Controller (Only Supplied with 1/4 HP Electric Stirrer Motor)
1ea CG-2046-90 Universal Stirrer Shaft Coupling
1ea CG-9253-20 Large Kwik Klamp II
1ea CG-3498-03 90° Support Rod
1. The support frame has a universal motor mount. It can be used with an (vertical or horizontal) electric, air, or
optional explosion proof (XP) motor. The mount automatically centers the motor directly above the reactor.
2. Attach the 1/4 HP electric motor via four socket head cap screws. Screws are shipped installed on the motor.
3. Attach the universal stirrer shaft coupling to the motor shaft.
4. When using the 1/4 HP electric motor, the digital controller, with mounting bracket on back panel, needs to be
mounted on the S.S. upright. Use the large Kwik Klamp II and the 90°S.S. support rod to mount the controller to
the support frame. Tighten all knobs securely.
*The Air Motor requires the air supply be filtered and a lubricator be installed between the air source and motor. Filter-
Regulator-Lubricator (CG-2025-10) is available separately.