Agri-Fab HA21362 - Manual (Page 5)

5
Assemble a spacer (24), a 1" washer (20), a wheel (5) 10.
(valve stem facing out), and then another 1" washer
(20) to the axle (4).
Secure with a 1/8 x 1-1/2" cotter pin (22), spreading
11.
the ends of the cotter pin with a pair of pliers bending
the ends around the axle.
Press hub cap (23) onto washer on outside of wheel.
12.
add grease 13. to wheel bearings using a grease gun.
Repeat for other wheel. 14.
FIGurE 6
SpacEr
wHEEl
1/8 x 1-1/2"
cottEr pIN
1" waSHEr
HuB cap add GrEaSE
FIGurE 7
3/8 x 1"
HEx Bolt
3/8" NylocK Nut
HaIr cottEr pIN
HItcH pIN
HItcH
BracKEt
Slide hitch into slot at end of tongue (8) and secure 15.
with a 3/8 x 1" hex bolt (13) and 3/8" nylock nut (16).
Assemble hitch pin (26) to hitch bracket (7) and tongue
16.
(8) and secure with a hair cotter pin (21).
opEratIoN
cautIoN: Vehicle braking and stability may
be affected with the addition of an accessory
or attachment. Be aware of changing conditions
on slopes.
do Not ExcEEd 800 lB. capacIty oF cart
One cubic foot of dirt weighs approximately 80 lbs.
The maximum towing speed for this cart is 10 m.p.h. 1.
Refer to vehicle owners manual for instructions on safe 2.
operation on slopes.
Use slope guide provided on page 13 of this manual to
3.
determine whether a slope angle is too steep for safe
operation.
Always test to make sure your tractor has adequate
4.
towing and braking capabilities whenever hauling a
substantial amount of weight in your cart. Use extra
caution when operating on slopes.
For best handling and traction, distribute the weight of
5.
the load evenly in the cart.
To dump material from the cart, remove the tailgate
6.
from rear of cart and then step down on latch step
bracket. After emptying, pull the front of the bed down
toward the cart tongue until the latch snaps into place.
Reinstall tailgate.
cautIoN: To avoid possible injury, be sure no
one is near cart before releasing latch.
cautIoN: do Not inflate tires beyond the
maximum recommended pressure printed on
side of tire.
maINtENaNcE
Check for loose fasteners before each use. 1.
Check for worn or damaged parts before each use. 2.
Keep tires filled to recommended tire pressure printed 3.
on the tire.
At the beginning of each season, using a light machine 4.
oil, lubricate the latch and the latch pivot bolt.
Pump grease into grease fittings on wheels periodically
5.
(at least once each season).
StoraGE
Clean thoroughly before storing. 1.
Remove any rust from painted surfaces and coat with 2.
touch up paint.
Store in a dry area.
3.