Nippon Aviotronics Multi-Function LCD Projector MP-50E User Manual
Page 4
E-4
• Do not look through the lens.
•
Do not look through the lens into the projector during operation. The powerful
rays passing through the lens could damage the eyes.
• Do not put the projector in unstable places.
•
Do not put the projector in unstable places such as on unstable desks or
slopes.
Doing so could cause the projector to drop or turn over, resulting in injury.
• Do not use any voltages other than specified.
•
Do not use any voltages other than specified. Doing so could cause fire or
electric shock.
• Do not disassemble the alkaline batteries
•
Do not short-circuit, disassemble, or burn the alkaline batteries.
Doing so could cause the alkaline solution to leak, which could cause eye
injury, as well as cause a fire or damage the surrounding area due to heat or
explosion. If the alkaline solution touches skin or clothes, wash them with
clean water. If it get into eyes, immediately wash them with clean water and
see a doctor.
• Do not bump the glass surface
•
Do not bump the glass surface over the scanner. Doing so may break the
glass, resulting in injury.
• Do not touch the air vents or lamp cover
•
The air vents, lamp cover, and peripheral surfaces may be hot during opera-
tion or just after the light is turned off.
Do not touch those for a long time.
• Do not block the lens front
•
Do not block the lens front during operation.
The powerful rays passing through the lens may cause fire or burns if you put
anything in front of the lens or block the lens with your hand during operation.
CAUTION
• Installation
•
Avoid installing the projector in places where it may be exposed to:
- Strong vibrations
- Soot or steam
- Direct sunlight or near a heater (35˚C/95˚F or higher)
- High humidity or dust
- Extreme cold (0˚C/32˚F or lower)
- Strong magnetic or electric field generated from a nearby appliance
- Wobbling on an unstable surface
• Do not block the air vents.
•
Do not block the air vents with cloth or an object.
When you put anything around the unit, be sure to ensure a space of 10 cm/4
inches or more between the unit and the air vent. Be sure to prevent paper or
cloth from blocking the air vent at the bottom of the unit. If blocked, the
internal temperature may increase, resulting in malfunctions.
• Do not bump the projector.
•
Avoid bumping the projector when moving or handling. Shocks can cause
damage.