Kramer Electronics VP-6A - Manual (Page 11)

Using Your VP-6A 1:6 UXGA / Audio / +1 CAT5 Distributor
9
negative sync polarity (or leave them in the left position (Normal) to
retain the sync polarity)
7. On the TP-122:
Connect the XGA OUT HD15F connector to the XGA acceptor (for
example, a display), and connect the AUDIO OUT S/PDIF RCA
connector to the digital audio acceptor (for example, an AV Receiver),
and the ANALOG 3.5mm mini jack to the analog audio acceptor (for
example, a stereo audio recorder)
Adjust 1 the video output signal level and/or cable compensation
equalization level, if required
If necessary, set the H SYNC and V SYNC switches 2 , on the underside
Figure 3: Connecting the VP-6A
1 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
2 By default, both switches are set down (for negative V SYNC and H SYNC polarity)