Kramer Electronics VP-727T - Manual (Page 17)

Technical Specifications
15
8.2 Making the Transition
You can make the transition in two ways:
Manually, for each separate transition using the T-bar control lever 1
Automatically, via the TAKE button, which implements the transition at
the pace set by the SPEED 2 knob
8.2.1 Making a Transition Manually
To make the transition, manually:
Slide the T-bar handle upwards 3 or downwards 4
8.2.2 Making a Transition Automatically
To make the transition, automatically:
Rotate the SPEED knob 2 to the right (increasing the transition speed) or
to the left (decreasing the transition speed). When the knob is turned to the
extreme counter-clockwise position (off), the switch will be engaged to turn
the knob off. In this position, the speed setting is controlled via the setting in
the VP-727 OSD menu
Pressing the TAKE button 5 causes the transition to occur automatically
9 Technical Specifications
Table 4 includes the technical specifications:
Table 4: Technical Specifications
6
of the VP-727T
PORTS: 4 sets of RS-485 3-PIN Terminal Block Ports
CONTROLS: Front panel buttons, RS-232, and RS-485
POWER SOURCE: 12 VDC, 240mA
DIMENSIONS:
19” (W), 3.4” (D), 4RU (H) rack mountable 7
WEIGHT: 1.58kg. (3.5 lbs.) approx.
ACCESSORIES: Gooseneck lamp, null-modem adapter, power supply, rack ears
kit 8 , and table-top brackets
1 Item 23 in Figure 1 and Table 1
2 Item 19 in Figure 1 and Table 1
3 The PREVIEW LED lights (item 21 in Figure 1 and Table 1)
4 The PREVIEW LED lights (item 22 in Figure 1 and Table 1)
5 Item 20 in Figure 1 and Table 1
6 Specifications are subject to change without notice
7 48.2cm (W), 8.6cm (D), 17.7cm (H)
8 A pair of rack ears, two spacers and ten screws