Kramer Electronics VP-727T - Manual (Page 9)

Installing in a Desktop
7
5 Installing in a Desktop
This section describes how to install the VP-727T in a desktop 1 .
To install the VP-727T in a desktop:
1. Cut an opening in the desktop—making the cut out on a wooden surface
using a sabre saw or a keyhole saw—at the location where you want to
insert the VP-727T. Figure 3 illustrates the cut out template (not to scale)
defining the surface that you have to cut out to install your VP-727T.
Figure 3: Cut Out Dimensions
2. Carefully insert the VP-727T unit into the prepared cut out opening, as
illustrated in Figure 4.
Figure 4: Inserting the VP-727T into the Prepared Cut Out Opening
1 Alternatively, you can use it freestanding on a table, or mounted in a 19” rack (see section 6)