Kramer Electronics VS-44HN - Manual (Page 16)

VS-44HN - Operating the VS-44HN 4x4 HDMI Matrix Switcher 13
11. Press the EDID button.
The process is complete when the display returns to normal.
6.2.3 Acquiring the Default EDID
To store the default EDID on a selected input (for example, Input 2):
1. Press the EDID and STO buttons simultaneously and hold them for 3
seconds.
Both buttons flash.
2. Press the input (for example, Input 2) to which the EDID is to be copied.
The selected input number flashes on the display.
3. Press the OFF button until "0" (zero) appears on the display.
4. Press the EDID button.
The default EDID is stored on the selected input when the display returns to
normal.
6.3 Storing and Recalling a Switching Setting from a Preset
You can use the STO and RCL buttons to store up to 8 setups and then recall
them using the OUT (1-4) and IN (5-8) selector buttons (see Figure 4 ).
Figure 4: Store-Recall Button Configuration
To store a switching setting (for example, to preset 8):
1. Configure the switching as required for the preset.
2. Press the STO button.
The STO button flashes.
3. Select an OUT or IN SELECT button to store the device setting (for example,
IN 4 for preset 8).