Kramer Electronics VS-44HN - Manual (Page 17)

14 VS-44HN - Operating the VS-44HN 4x4 HDMI Matrix Switcher
4. Press the LOCK button to store the current setup.
You have to press the LOCK button within 10 seconds or the procedure automatically
times out.
To recall a switching setting (for example, from preset 3):
1. Press the RCL button.
The RCL button flashes.
2. Press the relevant OUT or IN button that stored the preset (for example,
OUT 3/preset 3).
3. Press the LOCK button to recall the stored preset.
The RCL button stops flashing.
6.4 Switching Between Protocol 2000 and Protocol 3000
To switch from Protocol 2000 to Protocol 3000 and back again using the
front panel buttons:
1. On the TO OUTPUT 1 row, press Output buttons 1 and 3 at the same time.
Protocol 3000 is active.
2. On the TO OUTPUT 1 row, press Output buttons 1 and 2 at the same time.
Protocol 2000 is active.
Note that when sending consecutive protocol commands make sure to
maintain at least a 200ms delay between commands.
After performing EDID get/store commands, a 1 sec delay is required
before sending another protocol command.
6.5 Resetting the VS-44HN 4x4 HDMI Matrix Switcher
’s IP
Parameters
This procedure resets only the IP related parameters. All switching and
preset values remain unchanged.
To reset the IP parameters to their default values (see Section
9
):

Press and hold the RESET button on the rear panel while powering up the
device
i
i