Kramer Electronics VS-66HDCPxl - Manual (Page 19)

16 VS-66HDCPxl - Operating the VS-66HDCPxl 6x6 DVI Matrix Switcher
6 Operating the VS-66HDCPxl 6x6 DVI Matrix
Switcher
This section describes how to:

Route inputs to outputs (see Section 6.1 )

Disconnect outputs (see Section
6.2
)

Store and recall a setup (see Section
6.3
)

Acquire the EDID (see Section 6.4 )

Lock and unlock the front panel (see Section 6.5 )

Reset the Ethernet configuration to default values (see Section 6.6 )

Control the machine via the Ethernet port (see Section
6.7
)
6.1 Routing Inputs to Outputs
To route an input to an output:

Press an OUT key, followed by an IN key to route this input to that output
To route one input to all outputs:

Press ALL followed by an IN button. The input is routed to all outputs
6.2 Disconnecting the Outputs
To disconnect one output:

Press the OUT button of the output to disconnect and press OFF
To disconnect all outputs at once:

Press the ALL button and then press OFF. This disconnects all the outputs
6.3 Storing and Recalling a Setup
You can use the STO and RCL buttons to store up to 12 setups and then recall
them as illustrated in Figure 8 .
IN 1 is used for setup number 1 and OUT 1 is used for setup number 7.