Kramer Electronics VS-84H - Manual (Page 14)

Operating the VS-84H 8x4 HDMI Matrix Switcher
11
7 Operating the VS-84H 8x4 HDMI Matrix Switcher
This section describes:
• Switching an input to an output (see Section 7.1 )
• Acquiring the EDID (see Section 7.2 )
• Storing and recalling switch settings (see Section 7.3 )
• Resetting the VS-84H (see Section 7.4 )
• Connecting to the VS-84H via RS-232 (see Section 7.5 )
• Connecting to the VS-84H via Ethernet (see Section 7.6)
7.1 Switching an Input to an Output
To switch an input to an output:
• Press an output button followed by an input button to switch the
selected input to the selected output
7.2 Acquiring the EDID
You can acquire the EDID from any of the following:
• One output to one or more of the eight inputs (see Section 7.2.1 )
• Several outputs and inputs simultaneously (see Section 7.2.2 )
• The default EDID (see Section 7.2.3 )
Note: Attempting to acquire the EDID from an output that does not have a
display device connected to it results in the default EDID being acquired.
7.2.1 Acquiring the EDID from One Output
Note: You can assign the EDID from one output to any or all of the eight
inputs.
To acquire the EDID from a display device connected to one of the
outputs:
1. Press the EDID and STO buttons simultaneously and hold them for 3
seconds.
Both buttons flash.
2. Press the input button to which the EDID will be copied.
The selected input number flashes on the display.
3. Select the output from which the EDID is to be acquired.
4. Press the EDID button.
The EDID is stored when the display returns to normal and the EDID
and STO buttons stop flashing.