Kramer Electronics VP-790 - Manual (Page 19)

14 VP-790 - Configuring the VP-790 via the OSD MENU Screens
Setting Function
Component Sync Select the component sync: 3 Wire, 4 Wire, Auto
3 Wire: The sync signal is stripped from the green or Y channel (typical
for YUV)
4 Wire: The sync signal is derived from a separate sync line (typical for
RGB)
Auto: Automatically detects a sync signal
The Auto setting will automatically detect a sync signal and set-up the
VP-790 accordingly
SDI to HDMI Audio
Map Select the channels through which the SDI audio signal will be routed to
the HDMI output: Stereo ch(1,2), Stereo ch(3,4), Stereo ch(5,6), Stereo
ch(7,8) or multichannel
The SDI audio input is routed to the HDMI and 3G-SDI output
connectors by default. Two consecutive SDI audio channels can be
output on the HDMI/3GSDI output interface. The group can be chosen.
Or all eight SDI audio channels can be transmitted.
SDI Audio Routing Select HDMI & SDI or S/PDIF
H-Position Set the horizontal position according to the input resolution
For UXGA and component video inputs
V-Position Set the vertical position according to the input resolution
Frequency Adjust the frequency
For UXGA inputs
Phase Adjust the phase: 0 to 31
Auto image Assesses the image and improves the quality accordingly, by
automatically adjusting the phase, frequency and position