Kramer Electronics VP-790 - Manual (Page 41)

36 VP-790 - Firmware Upgrade
8.2 Saving User Settings
If you want to backup the user settings before upgrading the machine, you can do it
through the VP-790 Web pages. To do so, type the local IP address for the VP-790
in the Web browser’s address bar and press the ENTER button.
You can obtain/set the IP address via the OSD menu by entering the Network
Setup submenu within the Setup Menu or by connecting the VP-790 to an Ethernet
based network with the default DHCP setting to allow the VP-790 to obtain a valid
IP address from the network server.
Following firmware upgrade you may find that the VP-790 user settings have been
reset to their factory default values. If you wish to restore the user settings, you can
do it via the VP-790 Web pages.
8.3 Updating the Firmware
To upgrade the firmware:
1. Power down the VP-790.
2. Press and hold the menu button and turn the power On again. After a few
seconds, you can release the MENU button.
The VP-790 enters the firmware update mode.
3. Start the VP-790 Updater Tool application.
Figure 23: Updater Tool Window