Kramer Electronics SV-551 - Manual (Page 49)

Connecting via the ETHERNET
45
8 Connecting via the ETHERNET
You can connect the SV-551 via the Ethernet, using a crossover cable (see
section
8.1 ) for direct connection to the PC or a straight through cable (see
section 8.2 ) for connection via a network hub or network router.
8.1 Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the RC device to the Ethernet port on your
PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the RC device (192.168.1.39) during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select Properties.
3. Right-click Local Area Connection Properties.
4. Select Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
Figure 58 ).
Figure 58: Local Area Connection Properties Window