6 connecting the pl-50 power controller - monitor, Connecting the pl-50 power controller - monitor, Figure 4: connecting the pl-50 – Kramer Electronics PL-50 User Manual

Page 12

Advertising
background image

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Connecting the PL-50 Power Controller - Monitor

8

6 Connecting the PL-50 Power Controller - Monitor

To connect the PL-50, as illustrated in the example in

Figure 4

, do the following

1

1. Connect up to five

:

2

OUT 1 to a DVD player

outlets (from 1 to 5). For example, connect:

OUT 2 to an LCD display

OUT 4 to a power amplifier with speakers

OUT 5 to a lighting system

2. Set the DIP-switches (see

Table 2

).

3. Connect an item (for example, an alarm) via the RELAY and/or DIGITAL

CONTROL terminal block connectors (not shown in

Figure 4

).

4. As an option you can connect a PC and/or controller to the RS-232 port,

RS-485 port and/or the ETHERNET connector (see section

6.2.1

)

5. Connect the power cord

3

Figure 4

(not shown in

).

Figure 4: Connecting the PL-50

1 Be sure that the power is switched OFF on each device before connecting it to your PL-50. After connecting all the devices
to your PL-50, switch on the power of the PL-50, and then switch on the power of each device
2 You do not have to connect all the outlets. In this example OUT 3 is not connected
3 We recommend that you use only the power cord that is supplied with this machine

Advertising