Kramer Electronics RC-63DL - Manual (Page 15)

Using Your Room Controller
11
11
Table 8: RC-63D Rear Panel Features
# Feature Function
1 FIRMWARE UPGRADE Switch For technical support use only
2 Grounding Screw Connect to grounding wire (optional), see section 6.4
3 K-NET TERM Switch For line termination
4 PROGRAM (USB) Connector Connect to a computer for unit configuration
5 IR IN Receiver Receives IR remote commands
6 RELAY Connections Connect to room items (such as lighting, screen settings, and so on)
7 IR Connections Control a machine via an IR Emitter
8 RS-232 Connections Connect to the RS-232 connector on the A/V equipment or a PC or
other Serial Controller
9 K-NET LOOP Connections On K-NET and K-NET LOOP, PIN GND is for the Ground
connection 1
10
; PIN B (-) and PIN A (+) are for RS-485, and PIN +12V
is for powering the unit
K-NET Connections
11 FACTORY RESET Button Press to revert to the default settings, including all the configured
buttons
5 Using Your Room Controller
This user manual is applicable once the unit is installed and configured 2
• Configuration via Kramer K-Config Windows®-based configuration software
and/or the IR learner
. The
installation process is not detailed in this user manual, and includes:
• Setting up the labels on the buttons, according to your specific requirements 3
• Hardware installation
• Connecting the display
The room controller can function as:
• A master room controller that can connect to up to two auxiliary devices via
K-NET
• A standalone device (which is not connected to any auxiliary device)
• An auxiliary device connected to a master room controller
1 The ground connection is sometimes connected to the shield of the RS-485 cable (in most applications, it is not connected)
2 By authorized Kramer technical personnel or by an external system integrator
3 It is recommended to place labels on the buttons prior to installing the unit, as this involves removing the face plate