Kramer Electronics FC-10Dxl - Manual (Page 8)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Technical Specifications
6
5.1 Controlling via the REMOTE INPUT SELECT Connector
The contact closure remote control pins operate in a similar way to the input
selector buttons. Using the contact closure remote control lets you select an input
by remote control. To do so, temporarily connect the required input (CV or Y/C)
pin on the REMOTE INPUT SELECT terminal block connector to the G
(ground) pin, as illustrated in the examples in Figure 3.
DO NOT connect more than one PIN to the G PIN at the same time
To select the CV input, attach PIN CV to the G PIN: To select the Y/C input, attach PIN Y/C to the G PIN
Figure 3: Connecting the REMOTE INPUT SELECT Connector
6 Technical Specifications
Table 2 includes the technical specifications:
Table 2: Technical Specifications 1,2 of the FC-10Dxl
INPUTS: 1 CV on an RCA connector, 1 YC on a 4-pin connector
OUTPUTS: 3 RCA connectors: Y/G, B-Y/B/CV and R-Y/R/C, for use as CV, Y/C, RGB 3 , or
Component (Y/B-Y/R-Y); 1 Y/C on a 4-pin connector
BANDWIDTH (-3dB): 5MHz
DIFF. GAIN: 0.35%
DIFF. PHASE: 0.25 Deg.
K-FACTOR: 0.4%
S/N RATIO: 66.3dB
CROSSTALK (all hostile): <-66dB
CONTROLS:
Input selector and output format selector pushbuttons
POWER SOURCE: 12V DC, 210mA
DIMENSIONS: 21.5cm x 16.2cm x 4.4cm (8.46" x 6.38" x 1.73"), W, D, H
WEIGHT: 0.3kg (0.67lbs) approx.
ACCESSORIES: Power supply (2V)
OPTIONS: RK-1 rack kit
1 Specifications are subject to change without notice
2 Specifications are shown for PAL CV input and YC output, unless otherwise stated
3 Defined as RsGsBs (that is, there is sync on all three components of the RGB outputs)