Winland Electronics EA800-ip - Manual (Page 27)

Installation
D-011-0152 27
.
Figure 12 EA800 Console Wired 4-20mA Sensor Connections
Programming
When powered-up, the EA800 is ready for programming. The following is an overview of the general process for
programming the EA800:
■ View the MAIN MENU and unlock the EA800 as described in “Accessing the MAIN MENU for Programming” on
page 28.
■ Set the system configuration as described in “Configuring System Parameter Settings” on page 28.
■ Add the wireless sensors. See the appropriate subsection under “Adding Wireless Sensors” on page 29.
■ Add the wired sensors. See the appropriate subsection under “Adding Wired Sensors” on page 32.
■ Verify performance of the wireless sensors. See “Verify Wireless Signal Strength” on page 31.
■ Configure the relays. See “Configuring the Relays” on page 34.
Note: When no sensors are programmed in the EA800 system, the EA800 console boots up with a 30-minute
delay before the alarm buzzer sounds. At this time the Alarm screen is displayed with a System Alarm
caused by the fact that no sensors have been programmed yet. To prevent the System Alarm from acti-
vating, you must program at least one connected sensor into the EA800 console prior to the end of the
30-minute alarm time-out. If the alarm buzzer sounds press the Alarm Silence key to temporarily silence
the alarm buzzer.
4-20mA Sensors
(3-wire)
EA800
Console
Powered
External
Adapter
Powered
J6
Input N
User
supplied
cable
4-20mA
Transmitter
Connector
NC
J5
Aux Power Out
J6
Input N
User
supplied
cable
NC
J5
Aux Power Out
External
Power
Adapter
4-20mA
Transmitter
Connector
4-20mA
Output
4-20mA
Output
4-20mA Sensors
(2-wire)
J6
Input N
User
supplied
cable
4-20mA
Transmitter
Connector
NC
J5
Aux Power Out
EA800 Console
J6
Input N
User
supplied
cable
NC
J5
Aux Power Out
External
Power
Adapter
4-20mA
Transmitter
Connector
4-20mA
Output
4-20mA
Output
4-20mA Sensors
(4-wire)
J6
Input N
User
supplied
cable
4-20mA
Transmitter
Connector
NC
J5
Aux Power Out
J6
Input N
User
supplied
cable
NC
J5
Aux Power Out
External
Power
Adapter
4-20mA
Transmitter
Connector
EA800 Console EA800 Console
EA800 Console EA800 Console EA800 Console