Antunes, AJ MS-250/255 - Manual (Page 7)

MIRACLE STEAMER
6 P/N 1010699 Rev. B
A.J. Antunes & Co.
Unpacking
1. Remove unit and all packing materials from ship-
ping carton.
2. Open the large box. It should contain the follow-
ing:
• Miracle Steamer,
• Handle, Handle Guard & Shoulder Bolt,
(MS-150/250 only)
• Water Hookup Kit (MS-250 only).
NOTE: If any parts are missing or damaged, contact
Antunes Technical Service IMMEDIATELY at 1-877-
392-7854 or 1-630-784-1000.
3. Remove all packing materials and protective cov-
erings from the unit.
4. Remove and wash all removable parts in soap
and water. Rinse with clean hot water and allow
to air dry.
5. Wipe all surfaces of the unit with a hot damp
cloth.
NOTE: Do not use a dripping wet cloth. Wring out
before use.
6. MS-150/250 Models: Assemble the handle, han-
dle guard and mounting bolt to the spatula as
shown in Figure 1.
7. Re-install all removed parts.
Equipment Setup
GENERAL
When placing the unit into service, pay attention to the
following guidelines:
• Make sure power to the unit is off and the unit is
at room temperature.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or
counter.
ELECTRICAL
1. Place the unit on a sturdy, level table or other
INSTALLATION
Figure 1. Assembling Handle–MS-150/250 Only
Bolt
work surface. Turn the rocker switch (power
ON/OFF to OFF before proceeding.
2. Ensure that the line voltage corresponds to the
stated voltage on the units specification label and
power cord warning tag.
3. Connect the unit to the power supply.
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
208 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS UNIT IS DESIGNED TO OPERATE
ON 208 VOLTS ONLY. APPLICATION
WITH ANY OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL WARRANTY.
PLEASE CHECK YOUR LINE VOLTAGE
BEFORE INSERTING THIS PLUG INTO
THE RECEPTACLE.
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
220-240 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS UNIT IS DESIGNED TO OPERATE
ON 220-240 VOLTS ONLY. APPLICATION
WITH ANY OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL WARRANTY.
PLEASE CHECK YOUR LINE VOLTAGE
BEFORE INSERTING THIS PLUG INTO
THE RECEPTACLE.
Handle
Spatula
Guard
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
120 VAC
ONLY
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS APPLIANCE MUST BE
EARTHED GROUNDED
THIS UNIT IS DESIGNED TO OPERATE
ON 120 VOLTS ONLY. APPLICATION
WITH ANY OTHER VOLTAGE SUPPLY
COMPLETELY VOIDS ALL WARRANTY.
PLEASE CHECK YOUR LINE VOLTAGE
BEFORE INSERTING THIS PLUG INTO
THE RECEPTACLE.