American Standard BERWICK 7431.821 - Manual

1
2
5
4
GROOVE
(FAUCET
BASE)
MOUNTING
SURFACE
3
8
Figure A
M 9 6 8 6 4 0 R E V . 1 . 1
7 4 3 0 . 8 2 1
7 4 3 0 . 8 0 1
7 4 3 1 . 8 2 1
7 4 3 1 . 8 0 1
Certified to comply with ANSI A112.18.1
Installation
Instructions
SPREAD LAVATORY FAUCET
with
Speed Connect™ Drain
Adjustable Wrench Screwdriver Channel Locks
Recommended tools
Tubing Cutter
1
INSTALL FAUCET
NOTE: READ STEP #16 BEFORE INSTALLING SPOUT TO CONVERT FROM SWIVEL TO FIXED SPOUT.
Turn off hot and cold water
supplies before beginning.
CAUTION
7430.801
7430.821
7431.801
7431.821
1
BERWICK ™ / BOULEVARD ™
COLLAR ON
MOUNTING NUT
6
4
Figure B
Seat SEAL (1) into under side of SPOUT BASE (2).
Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN
CABLE ASSEMBLY (8) through the mounting hole of lavatory or
mounting surface. Figure A.
7
5
9
From below, slide DRAIN CABLE ASSEMBLY (8) and FAUCET SUPPLIES (3)
through opening in the SPACER (9) against underside of deck. Figure B.
Note: For thick deck installaitons the SPACER (9) is not required.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
Congratulations on purchasing your American Standard
faucet with Speed Connect drain, a feature found only on
American Standard faucets.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
Speed Connect Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
From below, push GASKET (7) and RETAINING WASHER (5) onto
MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6),
pulling faucet to front of sink, so SUPPLIES (3) rests against
mounting hole. Before final tightening, make sure collar on
MOUNTING NUT (6) is seated into RETAINING WASHER (5).
Figure B.
Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6)
to complete faucet mounting.