Section 5. specifications, Transmitter, Receiver – ADTRAN Tracer 2 x E1 User Manual
Page 55: Frequency plans, Spread spectrum data pump, Interface specifications, User interface, Pecifications
This section lists the specifications for the TRACER system.
Transmitter
Output Power
100 mW Transmitter ...................... +20 dBm, maximum
1 W Transmitter ............................. +30 dBm, maximum (Factory preset to +27 dBm)
Frequency Range .................................. 5725 to 5850 MHz or 2400 to 2483.5 MHz
Channel Bandwidth .............................. 62 MHz (5.8 GHz) or 40 MHz (2.4 GHz), (two channels)
IF
....................................................... 140 MHz
Receiver
Receive Level, range ............................ -30 to -89 dBm @ 2.4 GHz, (-30 to -87 dBm @ 5.8 GHz)
Receive Level, maximum ..................... -30 dBm
Receive Level, nominal ........................ -60 dBm
IF
....................................................... 70 MHz
Frequency Plan
Plan A 2.4 GHz .................................... Tx 2.421 GHz, Rx 2.462 GHz
Plan B 2.4 GHz ..................................... Tx 2.462 GHz, Rx 2.421 GHz
Plan A 5.7 GHz .................................... Tx 5.747 GHz, Rx 5.827 GHz
Plan B 5.7 GHz ..................................... Tx 5.827 GHz, Rx 5.747 GHz
Spread Spectrum Data Pump
Modulation ........................................... QPSK
Spreading Method ................................ Direct sequence
Code Length ......................................... 120 bits
Processing Gain .................................... >12 dB
Number of Codes ................................. 10
Chipping Rate ....................................... 12 times
Interface Specifications
Capacity ................................................ 2 x E1
Connection ........................................... RJ-48C, bantam
Line Code ............................................. AMI, HDB3
Framing ................................................ CAS, CCS
Alarms .................................................. LOS, OOF, CV, CRC, RMT, UA1
Loopbacks ............................................ Local and remote, per E1 channel
User Interface
Front Panel ........................................... Alarm LEDs, Configuration Switches, Monitor Jacks
Diagnostics ........................................... E1 Loopback, Remote Test with built-in BERT
TRACER 2 x E1 User’s Manual
45
S
ECTION
5
S
PECIFICATIONS