Cirrus Logic CDB5528 User Manual
Preliminary product information, Features, General description
Advertising
Table of contents
Document Outline
- CDB5521/22/23/24/28
- 1. Part I: Hardware
- 1.1 Introduction
- 1.2 Evaluation Board Overview
- 1.3 Using the Evaluation Board
- 1.4. Power Connections
- 1.5 Negative Bias Voltage
- 1.6 Software
- 1.7. Writing Your Own Interface Software
- Table 1. Header Descriptions
- Table 2. Microcontroller Read/Write Commands via RS-232
- Table 3. Microcontroller Conversion Commands via RS-232
- Table 4. Microcontroller Self Calibration Commands via RS-232
- Table 5. Microcontroller System Calibration Commands via RS-232
- 2. Part II: Software
- 2.1 Installation Procedure
- 2.2 Using the Software
- 2.3 Menu Bars Overview
- 2.4 Setup Window Overview
- 2.5 Data FIFO Window Overview
- 2.6 Histogram Window Overview
- 2.7 Frequency Domain Window (i.e. FFT)
- 2.8 Time Domain Window Overview
- 2.9 Calibration Window Overview
- 2.10 Trouble Shooting the Evaluation Board
- Figure 5. Main Menu
- Figure 6. Setup Window
- Figure 7. Data FIFO Window
- Figure 8. Frequency Domain Analysis
- Figure 9. Calibration Menu
- Figure 10. Time Domain Analysis
- Figure 11. Histogram Analysis (Using the CS5524 with default register settings and 24-bit output ...
- Figure 12. CDB5521/22/23/24/28 Component Side Silkscreen
- Figure 13. CDB5521/22/23/24/28 Component Side (top)
- Figure 14. CDB5521/22/23/24/28 Solder Side (bottom)