Cirrus Logic CDB5530U - Manual (Page 8)

CDB5530U
8 DS742DB1
2. SOFTWARE
The evaluation board comes with software and a USB cable to link the evaluation board to the PC. The
software is designed to run under Windows
®
2000 or later.
Important: DO NOT connect the evaluation board to the PC until you have completed the installation procedure and
have installed the USB drivers as described below.
2.1 Installation Procedure
2.1.1 CDB5530U GUI Software Installation Instructions
1. Ensure the CDB5530U USB cable is disconnected from the PC.
2. Open GUI software installation folder CDB553x_cvidistkit.Eval5534U
Ö
Volume1.
3. Run SETUP.EXE by double clicking on the filename.
4. Select Next, I Accept License Agreement, Next, Next, Finish.
2.1.2 Installing the USB Drivers
1. Apply power to the CDB5530U. Press and release the Reset switch, S1.
2. Use the included USB cable to connect the CDB5530U to the PC. The PC operating system should
automatically launch the Found New Hardware wizard.
3. From the installation wizard, select Install from a list or specific location (Advanced). Select Search
for the best driver in these locations.
4. Select Include this location in the search.
5. Click the Browse... button.
6. Go to folder C:/Program Files/Eval5534U/Driver and click OK.
7. Press the Next button.
8. A Hardware Installation dialog will appear. Press Continue Anyway.
9. Select Browse... and go to folder C:/Program Files/Eval5534U/Driver. Press Open.
10. A Files Needed dialog will appear. Press OK.
11. The Found New Hardware wizard will appear. Press the Finish button.
2.1.3 Running the GUI
Run the program by selecting Start
Ö
All Programs
Ö
Eval5534U
Ö
Eval5534_U.
2.2 Using the Software
Before launching the evaluation program, the user should select the proper jumper settings as described
in Section 1.