Cirrus Logic CDB8416 - Manual (Page 5)

CDB8416
DS578DB3 5
1.7 LED Function Indicators
Several LEDs are provided to indicate board func-
tions. D9 indicates that power is present to the
VD+/VA+ section of the CS8416 and CS8406.
D11, D12, and D13 indicate the status of the
NV/RERR, AUDIO, and 96 kHz output of the
CS8416 in Hardware Mode. See the CS8416 data
sheet for an explanation of the conditions that acti-
vate each of these outputs.
2. CONFIGURATION SETTINGS
CONNECTOR INPUT/OUTPUT SIGNAL PRESENT
J3 (+5V) Input +5 Volt Supply for supporting circuitry
J4 (GND) Input Ground connection from power supply
J5 (VL+) Input +3.3 to 5.0 Volt Digital Logic power for the CS8416 and CS8406
J6 (VD+/VA+) Input +3.3 Volt VD+/VA+ when not using the onboard regulator
J9, J16, J21 Input Digital Audio Interface coaxial input
OPT1-OPT4 Input Digital Audio Interface optical input
J2 Input Digital Audio Interface XLR input
J1 Input/Output Parallel port for connection to parallel port of PC
J20 Output Digital Audio Interface optical output
J19 Output Digital Audio Interface coaxial output
J10 Output Digital Audio Interface XLR output
J18 Input/Output I/O for CS8416 and CS8406 PCM data and clocks
Table 1. System Connections
JUMPER PURPOSE POSITION FUNCTION SELECTED
J7 Selects between using a separate supply for
VL+ or using the +5 Supply. ADJUST
+5V
Uses J5 to supply from +3.3V to +5.0V for VL+ Uses
J3 to supply +5V for VL+
J8 Selects between using a separate supply for
VD+/VA+ or using the onboard +3.3V regulator. REG
ADJUST
Uses the onboard +3.3V regulator for VD+/VA+
Uses J6 to provide the +3.3V supply for VD+/VA+
J12 Current measurement for CS8416 VA+ CLOSED
OPEN
Normal operation
Use J13 to measure CS8416 VA+ current
J13 Current measurement for CS8416 VD+ CLOSED
OPEN
Normal operation
Use J12 to measure CS8416 VD+ current
J17 Current measurement for CS8416 VL+ CLOSED
OPEN
Normal operation
Use J16 to measure CS8416 VL+ current
J14 Current measurement for CS8406 VD+ CLOSED
OPEN
Normal operation
Use J14 to measure CS8406 VD+ current
J15 Current measurement for CS8406 VL+ CLOSED
OPEN
Normal operation
Use J15 to measure CS8406 VL+ current
J11 Selects between coaxial or XLR output XLR
COAX
Selects XLR output on J10
Selects coaxial output on J19
Table 2. CDB8416 Jumper Settings