CPI Communications TTP216 Series - Manual (Page 8)

3. To Check the Existing Program:
OFF OFF OFF OFF OFF OFF OFF
ON ON ON ON ON ON
8 7 6 5 4 3 2 1
Y X F5 F4 F3 F2 F1 PROG
a. Turn the PROG switch ON.
b. During the first three seconds, the ABCD LED’s indicate the number of the currently loaded Pre-Set in binary form. This indication
flashes if the PRE-Set has been customized.
c. After the ABCD LED’s go out, switches F1 through F5 can be used to select a specific output to be checked.
d. The front panel LED's and the EIA Tone LED's indicate individual EIA Tone-to-Output assignment of the selected Output.
e. Normal operation resumes when all switches are returned to the OFF position. The existing settings are not modified.
TP200 Product Description - 5/23/01 Page 13 of 28
4. To Load a Pre-Set:
OFF OFF OFF OFF OFF OFF
ON ON
8 7 6 5 4 3 2 1
Y X F5 F4 F3 F2 F1 PROG
a. Turn the X switch ON.
b. Turn the PROG switch ON.
c. The ABCD LED's indicate Pre-Set number in binary form, starting with 0001.
d. Use the Tone Select pushbutton to step through the Pre-Sets. Press and release the Tone Select pushbutton to advance to the next
Pre-Set. Stop when the number of the desired Pre-Set is indicated in binary form on the ABCD LED’s.
e. To complete loading of the Pre-Set:
i. Turn the X switch OFF.*
ii. Turn the PROG switch OFF.*
The TTP200 will then return to normal operation.
*Turning the PROG switch OFF before turning the X switch OFF exits the Load function without saving the new Pre-Set.
Example: Loading Pre-Set #3
a. Turn the X switch ON.
b. Turn the PROG switch ON.
c. Press and release the Tone Select pushbutton until the ABCD LED’s indicate the number “3” in binary form, that is,
LED A = ON
LED B = ON
LED C = OFF
LED D = OFF.
d. Turn the X switch OFF.
e. Turn the PROG switch OFF.
f. The TTP200 is now ready for use.