FMI IDS - Manual

Before using any Fluid Metering, Inc. product read the following safety instructions
as well as specific product specifications and operating instructions.
Warning! Fire, electrical shock or explosion may occur if used near combustibles
explosive atmosphere, corrosive air, wet environment or submerged in fluid.
!
Caution! Fire, electrical shock, injury and damage may
occur if not used in accordance with Fluid Metering, Inc.
specifications and operation instructions.
Do not put wet fingers into power outlet of unit.
Do not operate with wet hands.
Do not operate drive assemblies that require a hard mount
(to be bolted down) unless they are mounted per Fluid Metering, Inc.
specifications, if not injury may occur and/or damage to unit.
Do not touch any rotating pump or motor components: injury may
occur.
Do not run pump dry, unless designed for that service.
Running dry is harmful to the pump, and will cause excessive heating
due to internal friction.
Check pump rotation and inlet/outlet pump port orientation before
connecting power to pump. If not injury may occur.
When pulling out cords from outlets do not pull cord, grasp plug to
prevent plug damage or electrical shock.
Fluid Metering, Inc. Drive Motors become HOT and can cause
a burn . DO NOT TOUCH!
Turn off the electrical power before checking pump for any problems.
Connect motor, speed controllers, or any other electrical devices
based on Fluid Metering Inc. specifications. Any unauthorized work
performed on the product by the purchaser or by third parties can im-
pair product functionality and thereby relieves Fluid Metering, Inc.
of all warranty claims or liability for any misuse that will cause
damage to product and/or injury to the individual.
Power cables and leads should not be bent, pulled or inserted by ex-
cessive force. Otherwise there is a threat of electrical shock or fire.
Replace any inline fuses only with fuse rating as specified by Fluid Me-
tering, Inc.
When pump/drive is under operation, never point discharge tubing into
face or touch any rotating components of pump.
In a power down thermal overload cut-in condition, unplug or turn off
power to pump. Always allow a cool down period before restarting:
otherwise, injury or damage may occur.
For 30 seconds after power is removed from pump/drive: do not
touch any output terminals. Electrical shock may occur because of
residual voltage.
!
SAFETY INSTRUCTIONS
!
General Instructions
Congratulations! You are about to install the newest technology from FMI, designed specifically
for industrial dispense applications, where long-term trouble-free performance is expected. If
you have any questions during any stage of your installation please don't hesitate to give us a
call. Our technical staff is ready with answers. Call us at 1-800-223-3388. LET'S GET
STARTED!
Your controller is initially set to provide one dispense per signal at 320 strokes per minute.* Dis-
pense signal, other speed settings, and dispense values are easily set by following the detailed
instructions on the following pages. * Best speed for most dispense applications.
Connect cable from CONNECTOR P1 on the housing to your PLC or controller and power sup-
ply as per the following pin connections. NOTE: Not all the available functions may be suitable
for your application; therefore some wires may not need to be connected.
1
1
IN-IDS-08
IDS INDUSTRIAL DISPENSER
INSTRUCTIONS