Hogtunes 2 Channel RoadGlide Amplifier Adaptor Plate - Manual

RG Adaptor Installation Instructions
Using the supplied nuts and screws, attach the USA 24.2 amplifier to the black steel plate as shown in Fig 1.1
Make sure to have the screws come through from underneath the plate. The supplied nuts are self locking, but a
thread adhesive material may be a good idea.
Fig 1.1: Amp positioned on adaptor plate
With the outer fairing off, remove the wire harness from the wire “strap” as shown by arrow “A” in Fig 1.2. This is
located on the brake side of the inner fairing.
The “B” arrow is where a larger factory “Molex” plug is secured to the frame (if present). Pull down on this Molex to
unclip it from the frame. Let this Molex hang for now. Note: Newer model bikes have this Molex located elsewhere.
The “C” and “D” arrows show the nuts that need to be removed so the RG adaptor plate can attach on the 2 main
studs. Once the plate is on, re-install these nuts to factory torque specifications. If you think the plate may rattle
against the inner fairing, use the supplied self adhesive foam tape to impede any rattling. RG adaptor plates have a
hole shown by arrow “E” so a supplied zip tie can re-secure the wire harness removed at arrow “A”. Secure the
wires so they cannot rub against the amplifier when the bike is moving. The Molex that was removed from the
frame (arrow “B”) can be re-secured to other wire harnesses using supplied zip ties (if Molex is present).
Go back to your Ultrasound Install manual to start wiring the USA 24.2 amplifier. Note: The RG Adaptor wire har-
ness passes from the fairing onto the bike through a rectangular opening where the throttle cable etc. pass
through. “Fishing” a small piece of wire through this opening first, taping the positive, negative, and rear speaker
wires to it, and using the “fish” to pull these wires through will reduce install time.
Make sure to use the wire harness that came with the RG Adaptor kit!
Harley-Davidson®, Electra Glide®, Road Glide®, Street Glide™, Ultra Classic®, and Tour-Pak® are Trademarks, and/or Registered Trademarks
of Harley-Davidson, Inc., Milwaukee, Wisconsin, USA, and if Used or Implied are for Reference Only.
There is No Affiliation Between Harley-Davidson, Inc., and Hogtunes Inc.
A
B
C
D
E
Fig 1.2: Amp and adaptor correctly installed
(prototype shown)
Hogtunes Inc, Barrie, Ontario, Canada , L4N-5C5 Tel: (705)-719-6361
email: [email protected] www.hogtunes.com
C