iRobot Mint 5200 - Manual (Page 27)

PAGE 27
Trouble Shooting
Solution
If cleaning with a wet cloth in Mop mode, try cleaning with a dry cloth in Sweep
mode on the same floor surface to determine if the issue occurs in both modes.
If using a cleaning solution on a wet microfiber cloth, try cleaning with only water to
determine if the solution could be causing Mint Plus to slip.
Make sure the cleaning cloth is attached properly and that the removable cleaning
pad is securely reattached to Mint Plus.
Try cleaning with a dry cloth in Sweep Mode on a different type of hard floor to
determine if the issue may be related to floor type such as an uneven floor surface.
Try these steps to help Mint Plus and the Cube find each other.
Turn off both Mint Plus and the Cube
Turn the Cube back on using the button on its corner. A blinking blue light
should appear on the opposite corner.
Place the Cube on a table or counter with the blinking blue light pointed toward
an open floor area where you can place Mint Plus.
Put Mint Plus on the floor in that open area about 6-7 feet from the Cube, with
Mint Plus facing toward the Cube.
Turn Mint Plus on and press the Sweep button (use a dry cleaning cloth).
Mint Plus should move toward the Cube (and then away from it again as it
encounters a wall or obstacle) and its blue lights should go from blinking to solid
within a minute or so.
When cleaning, position Mint Plus so it faces toward the Cube when it starts to
help it connect.